AudioCodes MP-20 Series - Configuring Media Streaming; Figure 9-4: Media Streaming Tab Screen

User's Manual 88 Document #: LTRT-50614
MP-20x Multimedia Home Gateway
9.3 Configuring Media Streaming
The procedure below describes how to configure the media streaming parameters.
 To configure media streaming parameters:
1. On the 'Voice Over IP' screen, click the Media Streaming tab; following screen
appears.
Figure 9-4: Media Streaming Tab Screen
2. Select the 'Enabled' check box under "Wide-Band Restrictions", to restrict Wide-band
codecs on FXS ports.
3. Configure the parameters, as required. For a description of the parameters displayed
on this screen, see Table 9-5.
4. Click OK to save your settings.
The following is an example of the relevant Telnet parameters:
rg_conf/voip/codec/0/enabled=1
rg_conf/voip/codec/0/name=PCMU
rg_conf/voip/codec/0/ptime=20
rg_conf/voip/codec/1/enabled=1
rg_conf/voip/codec/1/name=PCMA
rg_conf/voip/codec/1/ptime=20
rg_conf/voip/codec/2/enabled=1
rg_conf/voip/codec/2/name=G729
rg_conf/voip/codec/2/ptime=20
rg_conf/voip/codec/3/enabled=1
rg_conf/voip/codec/3/name=g726-16
rg_conf/voip/codec/3/ptime=20
rg_conf/voip/codec/4/enabled=1
rg_conf/voip/codec/4/name=g726-32
rg_conf/voip/codec/4/ptime=20