Chapter 7: GSoft2 – Getting Started
Page 7–9
DuRApulse GS4 AC Drive User Manual – 1st Ed, Rev A - 10/20/2017
SC OPE: Opens a functional graphic interface for testing and viewing selected drive parameter
data values (See the GSoft2 online helpfile for further detailed description).
IP Config: Allows manual configuration of an optional Ethernet card's IP address. Serial
(RS485) connection to the drive is required.
NE TWORK (Upgrade): Only available upon initial opening. Use this feature when upgrading
communication card firmware on your PC. Icon is “grayed out” and not accessible after
drive connection has been initiated.
Please read the important "Firmware Upgrade Notes" on page 7–10.
See the GSoft2 Helpfile for details on how to upgrade communication card firmware.
VF D (Upgrade): Only available upon initial opening. Use when upgrading GS drive firmware.
Only accessible prior to connecting to drive. Icon is “grayed out” and not accessible after
drive connection has been initiated.
Please read the important "Firmware Upgrade Notes" on page 7–10.
See the GSoft2 Helpfile for details on how to upgrade firmware.
NOTE: 500mA is required from the USB port of the sending PC. If unsure of the available current
supplied by the PC, please use a powered USB hub.
KE YPAD (Upgrade): Only available upon initial opening. Use when upgrading KEYPAD
firmware. Only accessible prior to initiating CONNECT. Icon is “grayed out” and not
accessible after drive connection has been initiated.
Please read the important "Firmware Upgrade Notes" on page 7–10.
See the GSoft2 Helpfile for details on how to upgrade keypad firmware.
To Next Page
Loading...
