Automation Direct DURApulse GS4 User Manual

Page B–4
DuRApulse GS4 AC Drive User Manual – 1st Ed, Rev A - 10/20/2017
Appendix B: Optional I/O and Communication Cards
OPtiOn CarD installatiOn anD reMOval
insTallaTion
1) Disconnect power to the GS4 AC drive.
2) Remove the digital keypad and cover to the GS4 AC drive. (See “Chapter 2: Installation and
Wiring” for detailed instructions.)
3) Install the circuit board.
a) Place the insulation spacer on the positioning pin at Slot 1.
b) Align the two holes on the circuit board with the positioning pin.
c) Push down on the circuit board until the board clicks into place under the retaining clip.
d) Fasten the circuit board with the M3 x 0.5 x 5mm long mounting screws. Tighten to a
torque of 5.21~6.94 in·lb (0.59~0.78 N·m).
Place the insulation*
spacer (Comm. Card
only) into positioning
pin at Slot 1.
Aim the two holes
on the PCB at the
positioning pin.
Press the pin to clip
the holes with the PCB.
Fasten Screws
5.21~6.94 in·lbs.
(torque 6~8 kg·cm).
Slot 1
r
ess t
h
e p
i
n to c
li
p
e
holes with the PCB
.
CLICK
d
c
a
b
* Insulation spacer assists in preventing accidental
contact of cable, board, and screw.
removal
1) Disconnect power to the GS4 AC drive.
2) Remove the digital keypad and cover to the GS4 AC drive. See Chapter 2 - Installation and
Wiring detailed instructions.
3) Remove the circuit board.
a) Remove the M3 x 0.5 x 5mm long mounting screws.
b) Push back on the retaining clip and lift the circuit board off of the positioning pin

Automation Direct DURApulse GS4 Specifications

General

Brand	Automation Direct
Model	DURApulse GS4
Category	Controller
Language	English