Chapter 8: GSLogic Introduction
Page 8–9
DuRApulse GS4 AC Drive User Manual – 1st Ed, Rev A - 10/20/2017
inStallation of GSloGiC ProGramminG Software
systeM requireMents
GSLogic Windows-based programming software environment. Please check the following
requirements when choosing your PC configuration:
•
Windows OS: 7: 32 & 64 bit, 8: 32 & 64 bit, 8�1: 32 & 64 bit, 10: 64 bit
•
SVGA 1024x768 pixels resolution (1280x1024 pixels resolution recommended)
•
300MB free hard-disk space
•
RAM: Windows 7 & higher
• with GUI version 2�0�0�x or higher, RAM = 2GB memory (4GB recommended)
• with GUI version 1�10 or lower, RAM = 512MB free RAM (1GB recommended)
•
USB Port for project transfer to GS4; USB-485M serial adapter required
about getting started
If you are familiar with Programmable Logic Controllers in general, then following the simple steps
in this chapter may be all you require to start being productive using a GS4 PLC system. After you
have completed the steps, your GS4 controller will be running the ladder logic project that you
programmed.
soFtware and online helP Files
The GSLogic programming software is available as a download from our website:
www.automationdirect.com/pn/gslogic
The GSLogic software includes searchable online help topics covering all aspects of the software,
instruction set, setup, and communications.
technical suPPort
We strive to make our manuals the best in the industry. We rely on your feedback to let us know
if we are reaching our goal. The feedback section of the Help File can be used to send a comment
to Technical Support. If you cannot find the solution to your particular application, or if for any
reason you need technical assistance, please call us at:
1–770–844–4200
Our technical support group will work with you to answer your questions. They are available
Monday through Friday from 9:00 A.M. to 6:00 P.M. Eastern Time. We also encourage you to
visit our web site where you can find information about our company and specific technical
information about a wide array of our products.
https://www.automationdirect.com
To Next Page
Loading...
Need help?
General
