Automation Direct DURApulse GS4 - Drive Analog Outputs

Page D–8
DuRApulse GS4 AC Drive User Manual – 1st Ed, Rev A - 10/20/2017
Appendix D: Using GS4 AC Drives with AutomationDirect PLCs
drive analog ouTpuTs
The GS4 has 2 analog inputs (AO1 and AO2) which can be configured for a variety of uses. The
outputs are configured via parameters and DIP switch settings (located above the I/O terminal
strip). There are several parameters associated with each analog output that defines the signal
and adjusts gain, offset, etc. Both outputs share the same Analog Common (ACM).
• AO1: 0 ~ 10V or -10V to +10V (see P4.50 and the DIP switch AO1 above the I/O terminals)
• AO2: 0 ~ 10V or 4–20mA (see P4.54 and the DIP switch AO2 above the I/O terminals)
analog ouTpuT Wired for volTage and CurrenT
In this example AO1 is configured for 0~10V (P4.50 and DIP switch AO1).
CLICK Expansion module
C0-04AD-2
CH1
CH2
CH3
CH4
0V
0V
0V
0V
0V
24V
0V
C0-04AD-2
0-10V
INPUT
GS4-xxxx
+10V Power Source
(20mA max.)
(0 to 10V)
(0–20 mA or 4–20 mA)
ACM
See Power
Wiring Diag.
CH3
CH2
CH1
24V
24VDC
Supply
Power
0V
0V
0V
0V
0V
Analog Voltage Sinking
Input Module
Analog Current Sinking
input Module
Control circuit terminal
Shielded leads
Main circuit (power) terminals
4–20mA
0–10V
C0-04AD-2
CH4
0V
CH3
CH2
CH1
24V
0V
0V
0V
0V
0V
C0-04AD-1
CH4
0V
AO1
AO2
+
–
24VDC
Supply
Power
+
–
Connect unused
channel(s)
to 0V terminals.
24
V
0V
0V
0
V
0
V
0
V
All “0V” terminals
are connected internally.
CHx
0V
24V
0V
0
V
0
V
0
V
0
V
All “0V” terminals
are connected internally.
AO1 is configured
for 0~10V
(P4.50 and DI
P switch AO1)
AO2 is configured
for 4~20mA
(P4.54 and DI
P switch AO2)
Analog Common
(same return path
for both drive
analog outputs)
CLICK Expansion module
C0-04AD-1
CH1
CH2
CH3
CH4
0V
0V
0V
0V
0V
24V
0V
C0-04AD-1
0-20mA
INPUT