Install Telecommunications Cabling
Patch Cord/Jumper Installation and Administration
446 SI Installation and Upgrades
June 2004
Figure 165: Coupled Bonding Conductor
Return to Task List
Figure notes
1 25-Pair Tip & Ring Cables to Cabinets
2 Coupled Bonding Conductor (CBC)
Terminal Block
3 Tie Wraps
4 Cable Shield or Six Spare Pairs
5 Ground on Carbon Block Protector or
Equivalent
6 Trunk Cable to Network Interface
7 10 AWG (#25) (2.5 mm
2
) Wire
8 To Network Cabinets
9 Battery Plant Ground Discharge Bar
for Single-Point Ground
10 Cross-Connect Ground Block
11 Main Distribution Frame (MDF)
12 To Other Cross-Connect Ground
Blocks
13 Approved Ground
14 Coupled Bonding Conductor (CBC)
cbc_gnd_1 PDH 062696
To Next Page
