Barco F90 - Page 71

17. Troubleshooting
Code E0000501: “Barometric pressure exceeded” (Error)
Situation Solution
Environmental pressure not within
range a s normally supported by the
projector.
Ensure that environmental conditions comply with the operation requirements of the
projector. See installation manual of the projector for d etailed installation requirements.
Code E0000700: “Humidity too low” (Error)
Situation Solution
Wiring issue
Verify the connection toward the humidity sensor.
Malfunction hum idity sensor (return
value = 0)
Replace the sensor.
Code E0000701: “Humidity exceeded” (Error)
Situation Solution
Environmental humidity too high.
Ensure that environmental conditions comply with the operation requirements of the
projector. See installation manual of the projector for d etailed installation requirements.
Code E1000101: “LaserDriver A bank 1 temperature exceeded” (Error)
Situation Solution
This error appears alone:
Lasersource bank 1 NTC
temperature exceeded due to
insufficient cooling of light source.
Check the tube connections between both the cooler(s) and the light source. Make sure
the tubes are properly connected and c heck for liquid spills or leakage.
Error appears alongside other Cooler
related errors.
Resolve c ooler related errors first.
Code E1000201: “LaserDriver A heatsink 1 temperature exceeded” (Error)
Situation Solution
This error appears alone: Insufficient
air flow through laser driver housing.
check for clogged vents OR the laser bank connected to the affected driver ou tput may
be partly or entirely short-circuited.
Error appears alongside other Cooler
related errors.
Resolve c ooler related errors first.
Code E1000300: “LaserDriver A bank 1 temperature reading failure” (Error)
Situation Solution
Not possible to reliably re ad out the
temperature of a specific laser bank.
Check wiring for that bank, from driver to light source. (Returned NTC tempera ture
value is impos sible).
Code E1000400: “LaserDriver A heatsink 1 temperature reading failure” (Error)
Situation Solution
Not possible to reliably read out the
temperature of a s pecific laser d river
heatsink.
Returned NTC temperature value is im possible. Check wiring to the laser driver module.
Code E1100101: “LaserDriver A bank 2 temperature exceeded” (Error)
For this error the same troubleshooting table can be applied to as for c ode E 1000101: “LaserDriver A bank 1 temperature exceeded”.
Code E1100201: “LaserDriver A heatsink 2 temperature exceeded” (Error)
For this error the sam e troubleshooting table can be applied to as for co de E1000201: “LaserDriver A heatsink 1 temperature ex-
ceeded”.
Code E1100300: “LaserDriver A bank 2 temperature reading failure” (Error)
For this error the same troubleshooting table can be applied to as for code E1000300: “LaserDriver A bank 1 temperature reading
failure”.
723–0016 F90 01/12/2017
69