17. Troubleshooting
Optional indicator
Optional indicator
Value
Comments
High 01h
Low 00h
Type
Type D escription
Note / Recommendation
INFO Messages of this type informs the user about an event or
status change.
WARN-
ING
Messages of this type warns the us er that system
performance will be impacted and/or stability/safety could
be compromised if no corrective action is taken.
An action by the us er to resolve the issue is advised.
ERROR Messages of this type alerts the user that system
performance or image quality (including no image) is visibly
impacted and/or stability/safety is comprom ised.
An immediate action by the user is r equired.
Only error and warning messa ges are enumerated in the troubleshooting list below.
17.4.2 Troubleshooting checklist
Code E0000000: “Environment temperature too low” (Error)
Situation Solution
Ambient temperature too low. M ake sure the projector operates within specs and m ake s ure that the installation
requirements are fulfilled.
Code E0000001: “Environment temperature exceeded” (Error)
Situation Solution
Ambient temper ature too high.
• Check the amb ient tempe rature at the front a ir inlets of the projector.
• Check airflow of the pro jector.
• Make sure the projector operates within specs a nd make sure that the installation
requirements are fulfilled.
Code E0000101: “Mainboard sensor temperature exceeded” (Error)
Situation Solution
Main bo ard is not sufficiently cooled.
• Check environm ental conditions.
• Check whether fans on main board are running as expected.
Code E0000201: “Mainboard IMX temperature exceeded” (Error)
For this error the sam e troubleshooting table can be applied to as for code E0000101 : “Mainboard s ensor temper ature exceeded”.
Code E0000301: “Mainboard FPGA temperature e xceeded” (Error)
For this error the sam e troubleshooting table can be applied to as for code E0000101 : “Mainboard s ensor temper ature exceeded”.
Code E0000401: “Mainboard Scaler FPGA temperature exceeded” (Error)
For this error the sam e troubleshooting table can be applied to as for code E0000101 : “Mainboard s ensor temper ature exceeded”.
Code E0000500: “Barometric pressure lower limit reached” (Error)
Situation Solution
Environmental pressure not within
range a s normally supported by the
projector.
Ensure that environmental conditions comply with the operation requirements of the
projector. See installation manual of the projector for d etailed installation requirements.
68 723–0016 F90 01/12/2017
To Next Page
Loading...
Need help?
General
