172
Settings
Always allow connection
When this function is activated the
corresponding external device can
establish a connection to the Cascade
without you authorising it.
! In the device list, select the device for
which the “Always allow connection”
setting is to be changed.
! Press the rotary control/push button
and hold until the following menu
appears.
! Select the Always allow connection entry.
! Press the rotary control/push button
to switch the function on ( ) or
off ( ).
Name device
You can change the name of a device
displayed in the Bluetooth device list.
! Select the device to be named from the
device list.
! Press the rotary control/push button
and hold until the following menu
appears.
! Select the Name device entry.
! Enter the desired name. For this
purpose, proceed as described in
“Data entry menus” auf Seite 13.
The changed name will be shown in the
device list.
Deleting a device from the list
You can delete devices from the
Bluetooth device list which are not used
or which are outdated.
! Select the device to be deleted from
the device list.
! Press the rotary control/push button
and hold until the following menu
appears.
! Select the Delete from list entry.
! When the next prompt appears, select
Yes to delete the entry or No to retain it.
The device will be deleted or retained on
the basis of the selection.
7032
7033
7034
Note:
A connected device is indicated in the
list in grey and can only be deleted after
the connection has been terminated.
7035
To Next Page
Loading...
Need help?
General
