67
Radio mode
Scan function
All stations in the station list are scanned
briefly to enable you to select the one
you require.
! In the status display, press and hold
down or .
or
! In the status display, press the rotary
control/push button .
The Options menu appears.
! Select the Scan entry.
! Press the rotary control/push button
to activate the function ( ).
The stations in the station list are
scanned briefly in descending/ascending
order.
Aborting the scan function
! In the status display, press or
.
or
! Turn the rotary control/ push button
.
or
! In the status display, press the rotary
control/push button .
The Options menu appears.
! Select the Scan entry.
! Press the rotary control/push button
to deactivate the function ( ).
The station currently being scanned is
set and the scan function is aborted.
Notes:
• If the selected entry is a station chain,
this is indicated by a small triangle on
the right-hand edge of the list.
Once a station has been selected, a
second list appears from which you
may select the required station from
the station chain.
Press to return to the previous
menu without selecting a station.
• Similarly, if a station transmits a
number of different regional pro-
grammes and regionalisation has been
activated as described in “Regionali-
sation” on page 71, a list will appear
from which you may select the
required station. Stations of this type
are identified in the station list by
(REG).
Note:
If the station memory is active and an
FM station is selected, then only
stations which have been stored in the
station memory are played when using
the scan function.
To Next Page
Loading...
