181
Settings
Setting the system language
You can select the language for
announcements and displays here.
! Select Set system language in the voice
mode settings.
! Turn the rotary control/push button
and then press the rotary control/push
button to select the required language.
The speaker selection list appears.
! Turn the rotary control/push button
and then press the rotary control/push
button to select the required speaker.
The language and the selected speaker
are installed.
Displaying voice settings
This function can be used to display the
currently valid voice settings.
! Select Show settings in the voice mode
settings.
The voice settings are displayed.
•
MMI language: indicates the current
setting for the display text language.
•
Navi speaker: indicates the current set-
ting for the navigation announcement
speaker.
•
SDS: indicates the current setting for
the voice dialogue system speaker.
• ččS: indicates the current language
setting for reading out texts.
Notes:
• The memory card containing the nav-
igation data or system CD must be
inserted in order to change the lan-
guage or speaker. If necessary, the
Cascade will prompt you to insert the
memory card/system CD.
• It may take up to 10 minutes to install
the language.
• When the system language changes,
voice entries created for stations and
addresses are deleted.
7004
Note:
• If other voices are available on an
inserted CD for the language cur-
rently selected, then these are also
displayed in the list of voices for this
language (only affects navigation
announcements).
• To update the voice dialogue, you
may be prompted to insert the system
CD. If you are, insert it.
7005
7006
To Next Page
Loading...
