184
Settings
Extended PTT
If the function is active, voice mode can
be activated automatically by pressing
, , , or
and you can input a voice command
directly.
! Select Pčč extended in the voice mode
settings.
! Turn the rotary control/push button
to switch the function on ( ) or off
().
Repeating a voice announcement
If the function has been switched on and
route guidance is active, the last naviga-
tion announcement can be repeated or an
updated navigation announcement out-
put by pressing .
! Select Repeat voice announcement in the
voice mode settings.
! Turn the rotary control/push button
to switch the function on ( ) or off
().
System settings
You can configure various basic settings
on your Cascade to meet your require-
ments in the system settings.
The following possible settings are
available:
For
Audio:
• Setting for speed-dependent increase
in volume with Speed-dependent volume.
•With
Micro sensitivity, the sensitivity of
the hands-free microphone for tele-
phone calls can be set.
• Using
Installation position of microphone,
you can specify whether your vehicle
is a left-hand drive or right-hand drive
vehicle.
• Setting for acoustic signal volume
with
Volume of warning tones
• You can use Display volume to select
whether a change in volume should be
displayed in graphics format.
• Setting for the volume level of digital
to analogue audio sources with
Digital
level
• You can use Supports parking aid to se-
lect whether the audio volume is to be
lowered when the reverse gear is en-
gaged.
Note:
The abbreviation PTT stands for “Push
To Talk”.
7012
7013
To Next Page
Loading...
