195
Voice mode
General information about the
voice control system
The primary principle of voice mode is
that you can read out all the commands
you can see in the display.
In order to optimise the ability of the
voice control system to understand the
commands, please note:
• Speak continuously and at normal vol-
ume. Avoid long pauses and excessive
emphasis.
• Observe the instructions about the
position of the microphone in the
installation guide.
• Make sure that you speak as directly
as possible into the microphone.
• Reduce interference by closing win-
dows, doors and the sliding roof.
• Avoid ambient noise in the vehicle
when entering voice commands (e.g.
conversations between other passen-
gers going on at the same time).
• Ambient noise increases the faster the
vehicle is travelling. You should
therefore speak more loudly at higher
speeds.
• Do not enter voice commands whilst
an announcement is being made.
Activating the voice control
system
The voice control system becomes avail-
able shortly after the Cascade is
switched on.
In order that conversations going on
inside the vehicle do not trigger the unit
accidentally, the voice control system
must first be activated before it can be
used.
! Press the rotary control/push button
.
The Cascade displays a border around
the current display and prompts you to
make an entry by emitting a signal
tone #. Voice dialogue starts.
Notes:
Depending on the setting in “Automatic
dialogue” on page 182, a voice dia-
logue will be started automatically
when , , , and
are pressed.
To Next Page
Loading...
Need help?
General
