179
Settings
Searching for Bluetooth devices
Use this function to start a Cascade
search for Bluetooth devices within the
transmission/ reception range.
All the devices (including those already
connected etc.) are displayed as a result
of the search.
! Call up the Bluetooth settings.
! Select the Search for devices entry.
The device displays
Searching for
Bluetooth devices
.
If a device is found the following
information is displayed, for example.
! Press the rotary control/push button
to cancel the search.
If you do not cancel the search it will
continue to run.
If other devices are found, further
messages will be displayed concerning
those devices.
The devices found are displayed in a list
after the search has been completed.
You can then connect/ disconnect the
devices as described in “Connecting and
disconnecting devices” auf Seite 173.
Making devices visible to others
Here you can specify whether other
Bluetooth devices are to be able to
recognise the Cascade or not.
! Call up the Bluetooth settings.
! Select the Device visible for others entry.
! Press the rotary control/push button
to switch recognisability on ( )
or off ( ).
7045
7046
7047
7048
To Next Page
Loading...
Need help?
General
