183
Settings
Voice entries
You can use this function to read out and
delete all voice entries already stored for
the radio and address book functions.
! Select Voice entries in the voice mode
settings.
Reading out:
! Select Read out radio or Read out add.
book
.
The selected voice entries are read out.
Deleting:
! Select Delete radio or Delete address
book
.
! When the next prompt appears, select
Yes to delete the entry or No not to
delete.
Entries will be deleted or retained on the
basis of the selection.
Voice output
You can configure voice outputs for the
Cascade here.
! Select Voice output in the voice mode
settings.
! You may now select the Signal prior to
voice input
, Confirm voice input and Detailed
voice output
functions.
•
Signal prior to voice input
Once the function has been activated,
in addition to being highlighted on the
Cascade, a beep tone sounds to
indicate that the unit is ready for a
voice command.
•
Confirm voice input
If the function is active, the voice
command is repeated by the Cascade
for confirmation. However, please
note that the voice command repeated
may not tally exactly with the voice
command you entered, but with the
main command. It may be the case, for
example, that you say “end” and the
Cascade repeats “cancel”. In voice
mode, these two commands have the
same meaning.
•
Detailed voice output
If the function is active, in some places
you will receive detailed instructions
(e.g. for entering a destination in voice
mode).
! Turn the rotary control/push button
to switch the required function on ( )
or off ( ).
Note:
The number of voice entries already
assigned appears on the right-hand side
of the display.
7010
7011
To Next Page
Loading...
Need help?
General
