Brady BMP 61 - AC Power Adapter; Brady AC Adapters; Attaching the Adapter

BMP
®
61 Label Printer User’s Manual 1-9
AC Power Adapter
AC Power Adapter
The printer can be powered through an AC/DC power adapter. When the adapter
is plugged in, it is also charging the BMP41-BATT NiMH battery (if installed).
Use only the 18 VDC, Brady AC/DC adapters, shown below, for
supplying power to the BMP
®
61.
Brady AC Adapters
Attaching the Adapter
Catalog Number Region
BMP41-AC North America,
Australia
M50-AC-INTL Europe
M50-AC-AR Argentina
M50-AC-BR Brazil
1. Insert the round end of the adapter
cable into the plug-in port on the
left side of the printer.
2. Plug the female end of the electrical cord into the
opposite side of the adapter. Plug the male end of
the electrical cord into an electrical outlet.