Brady BMP 61 - Replacing the Printer (Media Well) Cover

BMP
®
61 Label Printer User’s Manual 7-5
Replacing the Printer (Media Well) Cover
Internal Components
Replacing the Printer (Media Well) Cover
If the printer is accidently dropped, the media well cover may come off. If the
cover is not damaged, it can easily be re-attached to the printer.
To re-attach the printer media well cover:
1. Insert the cover locking tab on one side of the printer cover with its
corresponding locking groove on the printer.
2. Gently squeeze the other side of the media cover enough so its locking tab
can slip into the other locking groove of the printer.
3. Push down to snap the cover into place.