1-22 BMP
®
61 Label Printer
User’s Manual
Attaching the Strap
5. Weave the loose end of the strap back
over the first (lower) ring, then under
and through the second (top) ring.
6. Pull the loose end of the strap until it
feels tight, then press the scratch (burr)
fastener against the strap so it lays flat.
7. Slip your hand through the strap to
provide a secure grip when holding the
printer.
8. Or, use the third D-ring at the bottom of
the printer to hang the printer on a pole
or hooked device.
To Next Page
Loading...
