5-48
Confidential
1.4.25 Frame pattern print (Two-sided) (Function code 70)
<Function>
This function allows you to print one page of the frame pattern of the external circumference in
two-sided printing and check if there is print deflection.
<Operating procedure>
Before starting the procedure below, load paper whose size matches the default paper setting
of the region.
(1) Press the 7 and 0 keys in this order in the initial state of the maintenance mode.
"PRINTING" is displayed on the LCD, and the frame pattern is printed on both sided of the
paper. (Refer to the figure below.)
(2) When print is completed, "WAKU DX" is displayed on the LCD.
(3) To print the frame pattern again, press the Mono Start key.
(4)
Press the
Stop
key to return the machine to the initial state of the maintenance mode.
* # indicates the toner color (Y, M, or C) of which cartridge became empty.
Fig. 5-19
Note:
If printing fails, the following error indications are displayed and printing is cancelled.
To print again, refer to the measures in the table below and remove the cause of the
error. Then, press the Mono Start key. "WAKU DX" is displayed on the LCD, and
press the Mono Start key. "PRINTING" is displayed on the LCD, and the frame pattern
is printed on both sides of the paper.
Error message Measure
TONER EMPTY # * Replace the empty toner cartridge.
Cover is Open Close the joint cover ASSY.
No Paper Load paper into the paper tray, and close the paper tray.
Jam Tray1 Remove the jammed paper, and close the paper tray.
Jam Rear Remove the jammed paper, and close all the covers.
Jam Duplex Remove the jammed paper, and close the paper tray.
Duplex Disabled Load paper that is compatible with the two-sided printing into
the paper tray, and close the paper tray. Or close the back
cover.