Brother MFC-9840CDW - Back Cover ASSY

Confidential
3-48
Assembling Note:
(1) Put the Drive shaft holder into the Shaft of the Frame unit.
(2) Align the Hook and Pin of the Drive shaft holder with the hole on the Paper eject ASSY DX
while inclining the Drive shaft holder 10 degrees downwards.
(3) Move the Drive shaft holder to the direction of the arrow 3 to align it with the screw hole of
the Paper eject ASSY DX, and secure the Drive shaft holder with the bind B M3x10 Taptite
screw.
Fig. 3-26
8.8 Back Cover ASSY
(1) Remove the two cup S M3x8 Taptite screws, and then remove the Back cover ASSY.
Fig. 3-27
Hole
Paper eject ASSY DX
Paper eject ASSY DX
Taptite, bind B M3x10
Hook
Pin
Drive shaft holder
Drive shaft holder
Hole of screw
Shaft of the Frame unit
1
2
3
Taptite, cup S M3x8
Back cover ASSY
Taptite, cup S M3x8
<Back side>
Hook
Hook