BRP 2995 Johnson - Tachometer Pulse Setting; Water Pump Overboard Indicator; Operating Temperature

INSTALLATION AND PRE DELIVERY
INITIAL RUNNING CHECKS
Tachometer Pulse Setting
Confirm accuracy of tachometer reading.
• Adjust dial on back of tachometer to 6 pulse/12
pole
setting.
Water Pump Overboard Indicator
A steady stream of water should flow from the
overboard indicator.
----1
t==~ ::::::::
1. Water pump overboard indicator DRC4952
42
Operating Temperature
An outboard running at idle speed should achieve
a temperature based
on the engine's thermostatic
control. In general, the powerhead temperature
should reach at least 100°F (38°C) after five min-
utes of
idling. Confirm that the powerhead
reaches
idle temperature.