BRP 2995 Johnson - Water Pump

Remove the under panel, under panel gasket,
water
inlet housing, gasket, exhaust seal rubber,
and exhaust
seal core.
4
5
1. Under panel
004374
2. Water inlet housing
3. Gasket
4. Exhaust seal rubber
5. Exhaust seal core
Inspection
Inspect the impeller vanes for cuts, cracks, tears,
or excessive wear.
Replace is necessary.
Inspect the pump case and the under panel for
cracks, distortion, or corrosion.
Replace if neces-
sary.
004375
Inspect the water inlet housing for cracks or other
damage.
Replace if necessary.
GEARCASE
WATER PUMP
Inspect the oil seal for wear, cuts, nicks or tears.
Replace if necessary.
004376
Assembly
If necessary, remove the oil seal using Puller
Bridge, PIN 432127, and Small Puller Jaws,
PIN 432131 .
8-10 p1
Using an oil seal installer, drive a new seal into the
housing. The
seal lips should face the water pump
case.
Apply Trip/e-Guard grease to the seal lips.
1. Seal lip 004377
203
I
E
o
o
~
><
~
OJ
~
ii
E