CAPINTEC, INC. CAPRAC
®
-t
p-2 PREFACE March 2021
EQUIPMENT SAFETY CLASSIFICATION
• CLASS I EQUIPMENT energized from an external power source.
• TYPE B EQUIPMENT with no applied parts to the patient.
• Ordinary EQUIPMENT without protection against the ingress of water or particulates
(IP00).
• Suitable for CONTINUOUS OPERATION.
• NOT suitable for use in an OXYGEN or a FLAMMABLE ENVIRONMENT.
ELECTROMAGNETIC INTERFERENCE POTENTIAL
This equipment complies fully with interference immunity requirements of the standard
IEC 60601-1-2 “Medical electrical equipment: Part 1: General safety requirements; 2.
Supplementary standard: Electromagnetic compatibility”.
.
This equipment generates radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to nearby devices.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference, the user is encouraged to try to correct the
interference by one of the following measures:
• Increase the separation between the equipment and the affected device.
• Plug the unit into an outlet on a circuit different from that which the affected device is
connected.
If this fails to correct the problem, please contact Mirion Technologies (Capintec) Inc, which
is the only Authorized Service Center.
IMPORTANT SAFETY INFORMATION
The CAPRAC
®
-t Well Counter has been carefully designed to give you years of safe and
reliable performance. As with all electrical equipment, however, there are basic precautions
you must observe to avoid injuring yourself, the patient or damaging the equipment.
• Follow the unpacking and assembly instructions described in CHAPTER 4, and read
this manual carefully before using this equipment. Be sure to save all provided
documents for future reference.
• Understand all warning and caution labels as explained in CHAPTER 1: SAFETY
before operating this equipment.
To Next Page
Loading...
Need help?
General