CHAPTER 5
Cisco Unified Communications Manager Phone
Setup
•
Set Up Cisco IP Phone, page 67
•
Determine the Phone MAC Address, page 70
•
Phone Addition Methods, page 70
•
Add Users to Cisco Unified Communications Manager, page 72
•
Add a User to an End User Group, page 73
•
Associate Phones with Users , page 74
•
Survivable Remote Site Telephony, page 75
•
Enhanced Survivable Remote Site Telephony, page 77
•
Application Dial Rules, page 78
Set Up Cisco IP Phone
If autoregistration is not enabled and the phone does not exist in the Cisco Unified Communications Manager
database, you must configure the Cisco IP Phone in Cisco Unified Communications Manager manually. Some
tasks in this procedure are optional, depending on your system and user needs.
For more information about Cisco Unified Communications Manager Administration, see the documentation
for your particular Cisco Unified Communications Manager release.
Perform the configuration steps in the following procedure using Cisco Unified Communications Manager
Administration.
Procedure
Step 1
Gather the following information about the phone:
•
Phone model
•
MAC address
Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager
67
To Next Page
Loading...
Need help?
General
