Cisco CRS

PurposeCommand or Action
remote switching-capability lsc
Configures the unnumbered interface identifier. Identifiers,
which you specify by using this command, are the values
assigned by the neighbor at the remote side.
remote interface-id unnum value
Example:
RP/0/RP0/CPU0:router(config-mpls-te-if-adj)#
Step 6
remote interface-id unnum 7
Configures the remote node ID.
remote node-id node-id
Example:
RP/0/RP0/CPU0:router(config-mpls-te-if-adj)#
Step 7
remote node-id 10.10.10.10
Configures or updates an LMP neighbor and its associated
parameters.
neighbor name
Example:
RP/0/RP0/CPU0:router(config-mpls-te-if-adj)#
Step 8
neighbor OXC1
Configures the remote node ID.
remote node-id address
Example:
RP/0/RP0/CPU0:router(config-mpls-te-if-adj)#
Step 9
remote node-id 10.10.10.10
commit—Saves the configuration changes and remains
within the configuration session.
Use the commit or end command.
Step 10
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Verifies the assigned value for the local interface identifiers.show mpls lmp
Example:
RP/0/RP0/CPU0:router# show mpls lmp
Step 11
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
256
Implementing MPLS Traffic Engineering
Configuring GMPLS