Outgoing:
Explicit Route:
Strict, 24.9.0.2
Strict, 12.9.1.1
Strict, 1.1.1.1
Record Route: Empty
Tspec: avg rate=0 kbits, burst=1000 bytes, peak rate=0 kbits
Session Attributes: Local Prot: Not Set, Node Prot: Not Set, BW Prot: Not Set
Soft Preemption Desired: Not Set
Resv Info:
Record Route:
IPv4 24.9.0.2, flags 0x0
IPv4 12.9.1.1, flags 0x0
Fspec: avg rate=0 kbits, burst=1000 bytes, peak rate=0 kbits
Displayed 1 (of 104) heads, 0 (of 0) midpoints, 0 (of 201) tails
Displayed 1 up, 0 down, 0 recovering, 0 recovered heads
This example shows the automatically created backup tunnels.
RP/0/RP0/CPU0:router# show mpls traffic-eng tunnels auto-tunnel backup tabular
Tunnel LSP Destination Source Tun FRR LSP Path
Name ID Address Address State State Role Prot
----------------- ----- --------------- --------------- ------ ------ ---- -----
*tunnel-te400 2 1.1.1.1 4.4.4.4 up Inact Head Inact
*tunnel-te401 2 3.3.3.3 4.4.4.4 up Inact Head Inact
* = automatically created backup tunnel
RP/0/RP0/CPU0:router# show mpls traffic-eng tunnels auto-tunnel backup brief
TUNNEL NAME DESTINATION STATUS STATE
*tunnel-te400 1.1.1.1 up up
*tunnel-te401 3.3.3.3 up up
* = automatically created backup tunnel
Displayed 2 (of 104) heads, 0 (of 0) midpoints, 0 (of 201) tails
Displayed 2 up, 0 down, 0 recovering, 0 recovered heads
This example shows the attribute-set for auto-backup tunnels.
RP/0/RP0/CPU0:router# show mpls traffic-eng attribute-set auto-backup
Attribute Set Name: ab (Type: auto-backup)
Number of affinity constraints: 2
Include bit map : 0x4
Include name : blue
Exclude bit map : 0x2
Exclude name : red
Priority: 7 7 (Default)
Record-route: Enabled
Policy-class: 1
Logging: reoptimize, state
List of protected interfaces (count 1)
POS0_3_0_1
List of tunnel IDs (count 1)
3000
This example shows the attribute-set for auto-mesh tunnels.
RP/0/RP0/CPU0:router# show mpls traffic-eng attribute-set auto-mesh
Attribute Set Name: am (Type: auto-mesh)
Bandwidth: 100 kbps (CT0)
Number of affinity constraints: 2
Include bit map : 0x8
Include name : yellow
Exclude bit map : 0x2
Exclude name : red
Priority: 2 2
Interface Bandwidth: 0 kbps (Default)
AutoRoute Announce: Disabled
Auto-bw: Disabled
Soft Preemption: Disabled
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
359
Implementing MPLS Traffic Engineering
Configure the MPLS-TE Auto-Tunnel Backup: Example
To Next Page
Loading...
Need help?
General
