D-Link DWL-3600AP - Page 107

ConfiguringEmailAlert
D-Link UnifiedAccessPointAdministrator’sGuide
November2011 Page107
UnifiedAccessPointAdministrator’sGuide
UrgentMessage
Severity
Configurestheseveritylevelforlogmessagesthatareconsideredtobeurgent.
Messagesinthiscategoryaresentimmediately.Thesecuritylevelyouselectandall
higherlevelsareurgent:
•Emergencyindicatessystemisunusable.Itisthehighestlevelofseverity.
•Alertindicatesactionmustbetaken
immediately.
•Criticalindicatescriticalconditions.
•Errorindicateserrorconditions.
•Warningindicateswarningconditions.
• Noticeindicatesnormalbutsignificantconditions.
• Informationalindicatesinformationalmessages.
• Debugindicatesdebug‐levelmessages.
NonUrgentSeverity Configurestheseveritylevelforlogmessagesthatareconsideredtobenonurgent.
Messagesinthiscategoryarecollectedandsentinadigest
formatthetimeinterval
specifiedbytheLogDurationfield.Thesecuritylevelyouselectandalllevelsupto,
butnotincludingthelowestUrgentlevelar econsiderednonurgent.Messages
belowthesecuritylevelyouspecifyarenotsentviaemail .
SeetheUrgentMessagefielddescriptionfor
informationaboutthesecuritylevels.
EmailAlertMailServerConfiguration
MailServerAddress SpecifytheIPaddressorhostnameoftheSMTPserveronthenetwork.
MailServerSecurity SpecifywhethertouseSMTPoverSSL(TLSv1)ornosecurity(Open)for
authenticationwiththemailserver.ThedefaultisOpen.
MailServerPort
ConfigurestheTCPportnumberforSMTP.Therangeisavalidportnumberfrom0
to65535.Thedefaultis25,whichisthestandardportforSMTP.
Username Specifytheusernametousewhenauthenticationwiththemailserverisrequired.
Theusernameisa64‐bytecharacterstring
withallprintablecharacters.Thedefault
isadmin.
Password Specifythepasswordassociatedwiththeusernameconfigured inthepreviousfield.
EmailAlertMessageConfiguration
ToAddress1 Configurethefirstemailaddresstowhichalertmessagesaresent.Theaddressmust
beavalidemailaddress.Bydefault,noaddressisconfigured.
To
Address2 Optionally,configurethesecondemailaddresstowhichalertmessagesaresent.The
addressmustbeavalidemailaddress.Bydefault,noaddressisconfigured.
ToAddress3 Optionally,configurethethirdemailaddresstowhichalertmessagesaresent.The
addressmustbeavalidemailaddress.Bydefault,no
addressisconfigured.
EmailSubject Specif y thetexttobedisplayedinthesubjectoftheemailalertmessage.Thesubject
cancontainupto255alphanumericcharacters.ThedefaultisLogmessagefromAP.
Note:AfteryouconfiguretheEmailAlertsettings,clickApplytoapplythechangesandtosavethe
settings.
Table41:EmailAlertConfiguration(Cont.)
Field Description