D-Link DWL-3600AP - Figure 27: Modifying SNMP Settings; Table 36: SNMP Settings

ConfiguringSNMPontheAccessPoint
D-Link UnifiedAccessPointAdministrator’sGuide
November2011 Page96
UnifiedAccessPointAdministrator’sGuide
Figure27:ModifyingSNMPSettings
Table36:SNMPSettings
Field Description
SNMP
Enabled/Disabled
YoucanspecifytheSNMPadministr ativemodeonyournetwork.BydefaultSNMP
isenabled.ToenableSNMP,clickEnabled.TodisableSNMP,clickDisabled
. A fter
changingthemode,y
oumustclickApplytosaveyourconfigurationchanges.
Note: IfSNMPisdisabled,allremainingfieldsontheSNMPpagearedisabled.This
isaglobalSNMPparameterwhichappliestoSNMPv1,SNMPv2c,andSNMPv3.
Read‐only
communityname
(forpermittedSNMPget
operations)
Enteraread‐onlycommunityname.
Thevalidrangeis1‐256characters.
Thecommunityname,asdefinedinSNMPv2c,actsasasimpleauthentication
mechanismtorestrictthemachinesonthenetworkthatcanrequestdatatothe
SNMPagent.Thenamefunctionsasapassword,andtherequestisassumedtobe 
authenticifthe
senderknowsthepassword.
Thecommunitynamecanbeinanyalphanumericformat.