D-Link DWL-3600AP - Configuring SNMPv3; Configuring SNMPv3 Views

ConfiguringSNMPv3
D-Link UnifiedAccessPointAdministrator’sGuide
November2011 Page111
UnifiedAccessPointAdministrator’sGuide
Section6:ConfiguringSNMPv3
ThissectiondescribeshowtoconfiguretheSNMPv3settingsontheUAPandcontainsthefollowing
subsections:
• ConfiguringSNMPv3Views
• ConfiguringSNMPv3Groups
• ConfiguringSNMPv3Users
• ConfiguringSNMPv3Targets
ConfiguringSNMPv3Views
AMIBviewiscombinationofasetofviewsubtreesorafamilyofviewsubtreeswhereeachviewsubtreeisa
subtreewithinthemanagedobjectnamingtree.YoucancreateMIBviewstocontroltheOIDrangethat
SNMPv3userscanaccess.
AMIBviewcalled"all"is
createdbydefaultinthesystem.Thisviewcontainsallmanagementobjects
supportedbythesystem.
Figure34:SNMPv3Views
Note:Ifyoucreateanexcludedviewsubtree,cre a teacorrespondingincludedentrywiththesame
viewnametoallowsubtreesoutsideoftheexcludedsubtreetobeincluded.Forexample,tocreatea
viewthatexcludesthesubtree1.3.6.1.4,createanexcludedentrywiththeOID1.3.6.1.4.Then,create
an
includedentrywithOID.1withthesameviewname.