D-Link DWL-3600AP - Configuring SNMPv3 Users

ConfiguringSNMPv3Users
D-Link UnifiedAccessPointAdministrator’sGuide
November2011 Page115
UnifiedAccessPointAdministrator’sGuide
ConfiguringSNMPv3Users
FromtheSNMPv3Userspage,youcandefinemultipleusers,associatethedesiredsecurityleveltoeachuser,
andconfiguresecuritykeys.
Forauthentication,onlyMD5typeissupported,andforencryptiononlyDEStypeissupported.Thereareno
defaultSNMPv3usersontheUAP.
Figure36:SNMPv3Users
Table45
describesthefieldstoconfigureSNMPv3users.
Table45:SNMPv3Users
Field Description
Name EntertheusernametoidentifytheSNMPv3user.
Usernamescancontainupto32alphanumericcharacters.
Group Maptheusertoagroup.ThedefaultgroupsareRWAuth,RWPriv,andRO.Youcan
defineadditionalgroupsontheSNMPv3Groupspage.
AuthenticationType Selectthetypeofauthenticationtouse
onSNMPrequestsfromtheuser:
• MD5—RequireMD5authenticationonSNMPv3requestsfromtheuser.
• None—SNMPv3requestsfromthisuserrequirenoauthentication.
AuthenticationKey IfyouspecifyMD5astheauthenticationtype,enterapasswordtoenabletheSNMP
agenttoauthenticaterequestssentbythe
user.
Thepassphrasemustbebetween8and32charactersinlength.
EncryptionType SelectthetypeofprivacytouseonSNMPrequestsfromtheuser:
• DES—UseDESencryptiononSNMPv3requestsfromtheuser.
• None—SNMPv3requestsfromthisuserrequirenoprivacy.