D-Link DWL-3600AP - Appendix A: Default AP Settings; UAP Default Settings

DefaultAPSettings
D-Link UnifiedAccessPointAdministrator’sGuide
November2011 Page161
UnifiedAccessPointAdministrator’sGuide
Appendix A: Default AP Settings
WhenyoufirstpoweronaUAP,ithasthedefaultsettingsshowninthefollowingtable.
Note:TheDWL‐3600APsupportsoneradio,anditiscapableofoperatingintheIEEE802.11b,
802.11g,and802.11n(2.4GHz)modes.Radio1(802.11a/n)settingsdonotapplytothe
DWL‐3600AP.
Table66:UAPDefaultSettings
Feature Default
SystemInformation
UserName admin
Password admin
EthernetInterfaceSettings
ConnectionType DHCP
DHCP Enabled
IPAddress 10.90.90.91(ifnoDHCPser verisavailable)
SubnetMask 255.0.0.0
DNSName None
ManagementVLANID 1
UntaggedVLANID 1
IPv6AdminMode Enabled
IPv6AutoConfigAdminMode Enabled
RadioSettings
Radio(1and2) On
Radio1IEEE802.11Mode 802.11a/n
Radio2IEEE802.11Mode 802.11b/g/n
802.11a/nChannel A uto
802.11b/g/nChannel Auto
Radio1Channel
Bandwidth 40MHz
Radio2ChannelBandwidth 20MHz
PrimaryChannel Lower
ShortGuardIntervalSupported Yes
STBCMode On
Protection Auto
MaximumWirelessClients 200
TransmitPower 100percent