D-Link DWL-3600AP - Configuring SNMPv3 Groups

ConfiguringSNMPv3Groups
D-Link UnifiedAccessPointAdministrator’sGuide
November2011 Page113
UnifiedAccessPointAdministrator’sGuide
ConfiguringSNMPv3Groups
SNMPv3groupsallowyoutocombineusersintogroupsofdifferentauthorizationandaccessprivileges.
Bydefault,theUAPhastwogroups:
• RO—Aread‐onlygroupusingauthenticationanddataencryption.UsersinthisgroupuseanMD5key/
passwordforauthenticationandaDESkey/passwordforencryption.Boththe
MD5andDESkey/
passwordsmustbedefined.Bydefault,usersofthisgroupwillhavereadonlyaccesstothedefaultallMIB
view,whichcanbemodifiedbytheuser.
• RW—Aread/writegroupusingauthenticationanddataencryption.UsersinthisgroupuseanMD5key/
password
forauthenticationandaDESkey/passwordforencryption.BoththeMD5andDESkey/
passwordsmustbedefined.Bydefault,usersofthisgroupwillhavereadandwriteaccesstothedefault
allMIBview,whichcanbemodifiedbytheuser.
RWandROgroupsaredefinedbydefault.
To
defineadditionalgr oups,navigatetotheSNMPv3GroupspageandconfigurethesettingsthatTable44on
page114describes.
Figure35:SNMPv3Groups
Note:TheUAPsupportsmaximumofeightgroups.