D-Link DWL-3600AP - Radio Configuration from the CLI; Radio Configuration Using SNMP

ConfiguringRadioSettings
D-Link UnifiedAccessPointAdministrator’sGuide
November2011 Page168
UnifiedAccessPointAdministrator’sGuide
RadioConfigurationfromtheCLI
1. ConnecttotheAPbyusingTelnet,SSH,oraserialconnection.
2. TurnRadio2onifthestatusisnotcurrentlyup.
setradiowlan1statuson
3. SetthemodetoIEEE802.11b/g/n.
setradiowlan1modebg‐n
4. Setthechannelto6.
setradiowlan1channel‐policystatic
setradiowlan1static‐channel6
5. Setthechannelbandwidthto40MHz.
setradiowlan1n‐bandwidth40
6. Allowamaximumof100stationstoconnecttotheAPatatime.
setbsswlan1bssvap0max‐stations100
7. Setthetransmitpowerto75percent.
setradiowlan1tx‐power75
8. Viewinformationabouttheradiosettings.
getradiowlan1detail
RadioConfigurationUsingSNMP
1. LoadtheDLINK‐WLAN‐ACCESS‐POINT‐MIBmodule.
2. FromtheMIBtree,navigatetotheobjectsintheapRadiotable(apRadioBss>apRadioTable).
3. UsetheapRadioStatusobjecttosetthestatusofRadio2toup(1).
4. UsetheapRadioModeobjecttosettheRadio2modetoIEEE802.11b/g/n,
whichisbg‐n(4).
5. UsetheapRadioChannelPolicyobjecttosetthechannelpolicytostatic(1),whichdisablestheautomatic
channelassignment.
6. UsetheapRadioStaticChannel objecttosetthechannelto6.
7. UsetheapRadioChannelBandwithobjecttosetthechannelbandwidthforRadio2toforty‐MHz(2).
8. Usethe
apRadioTxPowerobjecttosetthetransmissionpoweronRadio2to75.
9. NavigatetotheobjectsintheapBssTable.
10. UsetheapBssMaxStationsobjecttosetthevalueofthemaximumallowedstationsto100.