D-Link DWL-3600AP - WDS Configuration Using SNMP

ConfiguringtheWirelessDistributionSystem
D-Link UnifiedAccessPointAdministrator’sGuide
November2011 Page171
UnifiedAccessPointAdministrator’sGuide
WDSConfigurationUsingSNMP
1. LoadtheFASTPATH‐WLAN‐ACCESS‐POINT‐MIBmodule.
2. FromtheMIBtree,navigatetotheobjectsintheapIfConfigtable.
3. WalktheapIfConfigNameobjecttoviewtheinstanceIDforthefirstWDSlink(wlan0wds0).
ThefirstWDSlinkisinstance1.
4. Setthevalueofinstance1intheapIfConfigRemoteMac
objectto00:30:AB:00:00:B0.
IntheMG‐Softbrowser,theformatfortheMACaddressvaluetosetis#0x000x300xAB0x000x000xB0.
5. Setthevalueofinstance1intheapIfConfigWdsSecPolicyobjecttoWPAPersonal(3).
6. Setthevalueofinstance1intheapIfConfigSsidobjecttowds
‐link.
7. Setthevalueofinstance1intheapIfConfigWdsWpaPskKeyobjecttoabcdefthijk.
SomeMIBbrowsersrequirethatthevaluebeenteredinHEXvaluesratherthanASCIIvalues.
8. PerformthesameconfigurationstepsonMyAP2.