Data General Service ECLIPSE MV/7800 - Removing Model 1605;1606 Cabinet from the Pallet

IMPORTANT
THIS IS A TWO PERSON OPERATION
-
_
INSERT JACK SCREWS
THROUGH HOLES IN 2 X
4'
S
1
ON PALLET. SCREW INTO
T—NUTS (BOTH SIDES).
E
-,_ -:
_
_
—
TURN JACK SCREWS INTO
PADS ON FLOOR. HOLES
ri
IN PADS UNE UP WITH
4
NIPPLES ON JACK SCREWS,
.
—
REMOVE SHIPPING BOLTS
05
FROM ONE END OF THE
1 ,7
BOTTOM OF CABINET.
• 
--- - - — -- -- -
al
SIMULTANEOUSLY TURN
2 JACK SCREWS TO RAISE
4
CUSHION MODULE FROM
FLOOR.
e.
0
6
REMOVE CUSHION MODULE.
0
lei, II 
o el
0
I* •
II  • col
REMOVE 2 BOLTS FROM
CUSHION MODULE.
SIMULTANEOUSLY TURN
2 JACK SCREWS TO
7
LOWER END OF PALLET
TO FLOOR.
HOLD MACHINE IN PLACE
AND REMOVE 2 REMAINING
eb
BOLTS AT BOTTOM OF
0 CABINET.
9
EASE MACHINE OFF PALLET.
JACK SI
1-NUT
FLOOR
FS-12730
Figure 6-3. Removing Model 1605/1606 Cabinet from the Pallet
043-003621 
6-10 
DGC
CONFIDENTIAL - INTERNAL USE ONLY