2. To enter normal operation from console program mode, do one of the following:
•
Place the LOCK switch to the OFF position. Halt the processor using the SCP HALT command.
Press the SYSTEM switch to the BOOT position to perform a load from the operating system
media.
•
Enter the Continue command to return control to the operating system or user program where it left
off.
•
Use the Start command to restart program execution from a different address.
•
Use the Boot command to manually boot a specific device.
2.6 ECLIPSE MV/7800 AND MV/7800-C RESET PROCEDURES
To reset the system perform one of the following steps:
•
Place the LOCK switch to the OFF position and then press the SYSTEM switch to the RST (reset)
position.
•
Use the Reset command.
2.7 POWER-DOWN PROCEDURES
To power-down the system, first reset the system and then place the POWER switch from the "ON-1" position to
the "0-OFF" position.
2.8 MV17800 COMSWITCH-II OPERATION MODES AND ACCESS LEVELS
This subsection contains information to operate the COMSWITCH-II.
NOTE
To enable/disable COMSWITCH-II, have the Data General Field
Engineer call the local support center for instructions on how to enable,
configure, and set the dialstring parameter.
NOTE
A <CMD BREAK> or <BREAK> is used when <BREAK> is called for
and depends on the terminal type.
2.8.1 Modes of Operation
comswrrcH-II
operating modes are determined by commands issued at the system console in the SCP-CLI> or
by a remote operator.
043
-
003621
2
-
6
DGC
CONFIDENTIAL - INTERNAL USE ONLY
To Next Page
Loading...