Data General Service ECLIPSE MV/7800 - BREAK>M - Remote Mode - SYSTEM

Example 2:
Remote center with multiple operators having individual outside lines and common portions of the
numbers.
Area code 404
Exchange 373
Number 6700 through 6799
The dialstring might be then set up as:
T 1,404<373 67>
The incoming caller would match the 37367 string and leave the remaining two digits 00 - 99 as an
'extension' to complete the number to be dialed.
For a complete description of modem commands, see the modem manual that was shipped with the
modem.
2.10.8 <BREAK>M - Remote Mode - SYSTEM
This command is used to connect the remote terminal to the 'ITO/TTI port of the MV/7800 computer and can
only be issued by the remote terminal. The command gives system console capabilities to the remote operator to
command the local system console. The command also does the following:
ENABLE local console (if DISABLED, Read-only, or Conversation)
Terminate USER mode (if in USER mode)
In response to the <BREAIC>M command, the following message will be received at the remote terminal and the
system console (and on the User terminal if in USER mode):
Possible error messages:
043-003621

2-18  DGC
CONFIDENTIAL - INTERNAL USE ONLY