Data General Service ECLIPSE MV/7800 - Page 39

2.10.5 <BREAK>E - End Session
This command is used to end the current connect mode and to disconnect the phone connection to or from the
remote terminal. The response at the commanding terminal to the <BREAK>E command is:
The phone connection will be broken. When the carrier loss is detected, the following message will be displayed
on the system console:
2.10.6 <BREAK>H - HELP
This command lists all available commands and the revision of the firmware. The response to the <BREA1C>H
command is:
DGC CONFIDENTIAL - INTERNAL USE ONLY

2-15 
043-003621