This command operates in toggle fashion. If the local terminal is ENABLED when this command is issued, it will
be set Read-only. If the local terminal is Read-only when this command is issued, it will be ENABLED. The
following events also cause the local terminal to be ENABLED:
<BREAK>E Command
<BREAK>M Command
<BREAK>N Command
<BREAK>U Command
Loss of carrier
(end remote session)
(enter SYSTEM mode)
(enter NORMAL mode)
(enter USER mode)
If the local terminal is ENABLED when the <BREAK>R command is issued, the response at the remote terminal
will be:
The response at the other terminal of the pair will be:
If the local terminal is Read-only when the <BREAIC>R command is issued, the response at the remote terminal
will be:
The response at the Remote terminal will be:
043-003621
2-20
DGC CONFIDENTIAL - INTERNAL USE ONLY
To Next Page
Loading...