To Next Page

To Previous Page

SOFTWARE CONFIGURATION

160

MATRIX 320

BACKUP AND RESTORE THROUGH DL.CODE

DL.CODE allows Backup and Restore to be performed to/from the configuration PC via

file or to an external storage device such as BM100/BM150.

DL.CODE provides complete backup and restore functions (Configuration and Environ-

mental parameters) with the following difference:

For Single Readers

or individual ID-NET Slaves:

• Backup and Restore functions provide parameter storage including all configura-

tion jobs present on the reader.

For Master Readers

in ID-NET Master/Slave networks:

• Backup and Restore functions provide parameter storage of only the Startup Con-

figuration for the Master and all Slaves present in the network.

Slave devices must always be configured with the same network baudrate as the Mas-

ter device for correct functioning including performing Backup and Restore proce-

dures.

When performing Backup and Restore to/from file, device firmware can be included.

Regardless of the reader network configuration, Backup to and Restore from external

device is supported by DL.CODE for all reading devices when connected to:

• CBX + BM100

• QLM-Series Gateways

CAUTION

For Master/Slave networks any other configurations (jobs) stored in the

device memory will not be backed up. Therefore, all jobs other than the

startup configuration will be overwritten (erased) upon a restore. It is

strongly recommended to save all configurations to backup files.

NOTE

Before executing a Backup to a BM100 backup module make sure the

Write Protection switch is set to Unlocked.

Datalogic Matrix 320 Product Reference Guide

Other manuals for Datalogic Matrix 320