6. Operation AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
104 Operating Instructions (Version 03/2018)
Fig. 6-10 Program Manager > Select set
6. Select the desired program type Click [OK] (press [ESC] to return to the Program
Manager).
7. The "Set Manager" window appears and shows you the manufacturer-specific sets for you
firing furnace.
Fig. 6-11 "Set Manager" window
8. Select the desired set.
9. Click on [Load].
(Press [ESC] to return to the Program Manager without loading the set.)
10. The Program Manager displays the "Load set" window. Continue as described in section
6.6.2.
The message
"Successfully loaded" appears after the set has been loaded. Click [OK] to return
to the Program Manager.
To Next Page
Loading...