5. User interface AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
40 Operating Instructions (Version 03/2018)
5. User interface
5.1. Basic information
5.1.1. Terms
The following table explains some of the basic terms that will make it easier to operate the
AUSTROMAT
®
.
Term Explanation
Program XE "Firing
program"
Firing programs or other programs contain the individual control
commands for the AUSTROMAT
®
. A typical example of a program
is the preheating program that is the first program memory for
most firing furnaces.
Program parameter
XE "Firing parameters"
The individual values within a program are termed the program
parameters or firing parameters. Program parameters are for
example the starting temperature, drying time, and closing time.
Set Compilation of all programs (program list) in the Program
Manager.
Tab. 5-1 Definition of terms
To Next Page
Loading...