Dekema AUSTROMAT 674 baSiC - 7.4. Changing the Heating Element; 7.5. Software Update Procedures

7. Maintenance and Service AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
116 Operating Instructions (Version 03/2018)
7.4. Change the heating element
NOTE:
Before each maintenance and service task: Read section 2, Safety. In particular, be aware
of the hazards listed in section 2.4.
NOTE
:
If technical servicing or repairs are necessary, they should only be performed by
authorized professionals (see section 7.7).
Over time, the heating el
e
ment wears out from use. This can have a negative influence on your
firing results. For this reason, change the heating element at the proper time. If the self-check
program is run regularly (see section 7.3), a recommendation will be displayed when the
heating el
em
ent wear exceeds the permissible limit. Follow the accompanying installation and
safety instructions in section 2 to install the replacement heating element. Heating elements
sho
uld only b
e replaced by trained professionals.
7.5. Software update
Contact DEKEMA to update the software program for your firing furnace. An update can be
obtained in the following ways:
• by mail on a thumb drive,
• by e-mail,
• by online update. See section 5.8.4.5.
The mail deliv
eries come with detailed step-by-step instructions to install the program update
(on paper or in a PDF file).