2. Safety AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
22 Operating Instructions (Version 03/2018)
CAUTION
Ceramic dust from insulation materials.
The firing chamber and insulation table consist of ceramic
insulating material. Inhaling ceramic dust can be hazardous to
your health.
Do not inhale the dust. To remove ceramic dust, use a suitable
vacuum cleaner. Read the safety data sheets for the insulation
materials in section 9.
2.5. Access rights
Three levels are defined for accessing the user interface of the AUSTROMAT
®
firing furnace.
Access levels 1 and 2 (see following table) are password-protected. The passwords are defined
in the "Service" menu using the "Password" function.
The access rights should be issued to the users of the firing furnace based on their knowledge,
experience and responsibility.
The firing furnace normally starts in the "Operation" menu. When "General Code" is used, it
starts one level higher (level 0).
Access levels Description
General code (level 0)
• Restricted access to the "Setup" menu
• Selecting blocked programs and starting them
• Edit and create unblocked programs
• Unlocking the General Codes
Operation (level 1)
• Select all programs and start them
• Edit and create all programs
• Access to the "Setup" menu
Service (level 2)
• Access to the "Service" menu
Tab. 2-1 Access levels
2.6. Stop function
Press the [ON/OFF] key on the graphical user terminal. All the commands that the firing oven is
executing in standby mode, i.e. no program is running, are immediately interrupted without a
query.
To Next Page
Loading...