Dekema AUSTROMAT 674 baSiC - 6.3.2. Starting Programs via VNC

6. Operation AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
92 Operating Instructions (Version 03/2018)
6.3.3. With VNC program (optional)
NOTE:
This functionality is available as an option.
• The options that are enabled for your firing furnace can be found in the menu
Setup > Furnace ID > Options (see section 5.8.2.1).
• You can find
information
on enabling options in section 7.6.
NOTE:
To use the firing furnace via a VNC, a suitable VNC program needs to be installed on the
computer. The VNC function of the firing furnace must be activated (section 5.8.1.5).
Start the VNC progr
am
1.
Start the VNC program on the computer.
2. Enter the IP address for the firing furnace and the password (see section 4.5.3). The
Program Man
ager o
pens (see section 5.3).
The remainin
g procedure is the same as that in section 6.3.1.