Dekema AUSTROMAT 674 baSiC - 6.10.2. X-Dream Quality Management; 6.10.3. OPC for Quality Management

AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
6. Operation
Operating Instructions (Version 03/2018) 109
6.10.2. X-Dream (optional)
NOTE:
The requirements for using X-DREAM
®
are:
• X-DREAM
®
is installed on the computer,
• the firing furnace is configured for a network connection,
• the firing furnace is configured for access via an FTP server.
The optional X-DREAM
®
program ("Extended DEKEMA Remote Access Management") offers
an additional level of quality management for firing furnaces:
• handling dfl files,
• querying the status of the firing furnace via a computer using QM information
• Automatically sending QM logs by e-mail:
Start X-DREAM
®
(for example by double-clicking the program name "X-DREAM_v20.exe"). The
following window offers an example.
Fig. 6-18 Example of X-DREAM
For additional information, please contact DEKEMA (see section 7.7).
6.10.3. OPC (optional)
NOTE:
The requirements for using OPC are:
• OPC is installed on the computer,
• the firing furnace is configured for a network connection,
• the firing furnace is configured for access via an FTP server.
OPC ("OLE for Process Control") is a standardized software interface that allows you to
exchange data between applications by different manufacturers.
By using the optional OPC program by DEKEMA, you can integrate quality management for the
firing furnace into an ERP system ("enterprise resource planning").
For additional information, please contact DEKEMA (see section 7.7).