4. Start-up AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
34 Operating Instructions (Version 03/2018)
3. The login window appears.
a. Enter the password in the “Password” entry line.
b. Select the desired data compression for transmitting data between the firing oven and
the computer. We recommend using the default setting, "RL encoding".
c. Click on [OK].
Fig. 4-5 Login window
4. The Program Manager appears in the browser (see section 5.3).
Set up a permanent IP address for the firing furnace (see section 4.5.4).
Recommend
ation: Define bookmarks in the browser
You can define a bookmark in the browser for easily opening the firing furnace control: In the
browser, enter the permanent IP address, and start the Java application. Wait until the Program
Manager is displayed. Define the bookmark.
4.5.3. Setting up the operation of the firing furnace using a VNC program
NOTE:
To use the firing furnace via a VNC, a suitable VNC program needs to be installed on the
computer.
1. Open a VNC program on a computer network (such as RealVNC or UltraVNC).
2. The start window appears.
a. Enter the noted IP address in the "Server" entry line ("192.168.115.200" in the
following example).
b. Click on [OK].
Fig. 4-6 Enter the IP address in the VNC start window (example)
To Next Page
Loading...