4. Start-up AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
30 Operating Instructions (Version 03/2018)
4.4. First Startup
4.4.1. Procedure
NOTE:
When connecting the firing furnace:
• The firing furnace is operated using mains voltage.
• Use only suitable power sockets with ground contacts, and never use adapter plugs.
• Do not run the connection lines past places of the firing furnace that are hot, and
especially avoid direct contact.
1. Make sure that the firing furnace is turned off. The ON/OFF switch is on the back of the
furnace (see section 3.3).
2.
If you want to operate the fi
ring furnace through a network (Ethernet): Connect a network
cable to the interface on the back of the furnace (see section 3.3).
3. If you want to operate the fi
ring furnace with a computer (Ethernet): Connect a crossover
network cable to the interface on the back of the furnace (see section 3.3).
4. Plug in the po
wer cable of the firing furnace into a power socket with a ground contact.
5. Turn on the firing furnace. The control of the firing furnace starts up over a period of about 1
minute. The firing furnace performs an internal software and hardware check, and the lift
moves down automatically.
6. Make sure that the insulating table is mounted on the lift seat. If not: Turn the firing furnace
off, and mount the insulating table.
7. If necessary: Remove any ceramic dust from the lift seat and the sealing ring. Brush the
dust into a receptacle. Do not blow away the dust, and do not inhale it.
8. The following ways exist to operate the firing furnace (control software):
• Operation using the touchscreen and function keys, see section 3.2,
•
Operation u
sing the touchscreen with the USB mouse and USB keyboard (via a USB
hub), see section 3.2,
•
Optional op
eration using a network computer: Connect the firing furnace to the
network (see section 4.5).
•
Optional o
peration using an individual computer: Connect the firing furnace to the
computer (see section 4.6).
To Next Page
Loading...