AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
4. Start-up
Operating Instructions (Version 03/2018) 27
4. Start-up
4.1. Unpacking and setting up
WARNING
The firing furnace is heavy.
When the firing furnace is transported, there exists the danger
of crushing, and the device may become damaged.
Two persons must transport the firing furnace. Wear safety
gloves.
Packaging symbols.
The packaging can be identified with the packaging symbols shown below. The symbols must
be followed.
123 4 567
Fig. 4-1 Packaging symbols
1 Top 5 Do not use hooks
2 Fragile 6 Center of gravity
3 Protect from moisture 7 Lifting point
4 Keep away from heat
Unpacking
1. Remove the packaging, and keep the packaging material for storing the firing furnace or for
later transport.
2. Make sure that all of the parts listed in the scope of delivery are in the delivered package;
see section 1.3.
3. Che
ck the delivery for transportation damage. Notify immediately of any complaints.
4. Transport the firing furnace to the provided setup site (see section 4.2).
NOTE:
It is possible that the firing furnace may not be safe to use when there is visible damage
to the housing or power cable.
To Next Page
Loading...