AUSTROMAT
®
664 iSiC
®
/ 674 baSiC
2
4. Start-up
Operating Instructions (Version 03/2018) 31
4.4.2. Installation assistant (country-specific)
The (country-specific) Installation Assistant program is also activated in the factory before the
delivery.
The installation assistant asks you to mount the insulation table, and runs an installation routine
after you confirm by pressing the [CONTINUE] key: The firing chamber is dried, and the firing
furnace is checked. The installation routine takes approximately three hours, and can be
terminated at any time with the [ABORT] key. The installation assistant is started each time the
furnace is turned on until the entire installation routine has run once.
NOTE:
After the installation routine is finished, a message appears and asks you to close the
firing chamber to prevent wear. This message always appears when the firing chamber is
opened for more than 15 minutes and the chamber temperature is above 200°C.
• Acknowledge the message.
• Close the firing chamber.
To Next Page
Loading...